- POWER TOOLS
- AIR TOOLS
- METALWORKING TOOLS
- MANUAL TOOLS
- WOODWORKING TOOLS
- OTHER TOOLS
- BATTERY CHARGER
- BATTERY TESTER
- CLEANING TOOLS
- CORDLESS
- DRAIN / PIPE CLEANER
- DRILL BIT SHARPENER
- HOBBY CRAFT ESSENTIALS
- MATERIAL HANDLING EQUIPMENTS
- MEAT BANDSAW
- PLASTIC BAG SEALER
- PLASTIC CUTTING MACHINE
- PLASTIC HANDLING TOOLS
- SUBMERSIBLE WATER PUMP / NON SUBMERSIBLE WATER PUMP
- TILE / STONE CUTTING
- TM TOOLS GRINDING SERIES
- Others
- View All
- CAR WORKSHOP ESSENTIAL
- CORDLESS
- ELECTRICAL TOOLS
- GARDEN TOOLS
- INSTRUMENTS
- MATERIAL HANDLING EQUIPMENTS
- Others
PEAK LIGHT BOX, 81X50X25MM 2X AA BATTERY PEA-2046
|
PEAK LIGHT BOX, 81X50X25MM 2X AA BATTERY PEA-2046$ 64.00 In Stock
Quantity
|
Light Box for 2026 series Peak Hand/Microfilm viewers.
The Light Box is a new item with an auxiliary lighting source to be used where the supply of light is not sufficient when you use the Lupe 8X with Puncher & Holder or Microfilm Viewers 15X and 20X, and Hand Viewer 8X (item 2026). (Two kinds of white diffusing plastics are used for the light box).
The plastics with a hole in the center is for No. 2018-SET and the one without hole is for No. 2026 series).
When you want to use the light box for No. 2018-SET, 2018loupe, 2018-PH (Puncher and Holder)
It is very simple and easy to connect the Light Box to the Microfilm Viewers.
A small rectangular metal plate is enclosed for the purpose of the connection. Put the small metal plate with a paper cover upward horizontally just on the magnet of Light Box. Then, peel the paper cover from it and fit the Microfilm Viewer, sliding it into the inner side along the both guides, on the white diffusing plastics until it stops at the end. Press the Viewer down from above so that metal plate with adhesive on the surface will stick to the bottom of the Viewer. Now, you can use the Light Box properly. When you like to detach the Microfilm Viewer from the light box, just lift it up with light box holding in your hand.
.png)
